This treating system consists of our patented G3 Seed Treater,TX7E auger, and a Mix and Treat liquid product delivery unit. The G3 is made of stainless steel body. The fittings inside are brass and stainless steel.
The TX7E auger is 3.692 meters long and has a 17.78cm tube diameter. There is a shield at the top to guard the pulleys. The bottom has a cage that covers all exposed flighting. The auger flighting is poly cupped. The spout at the discharge is designed to keep the G3 hanging vertically straight. We have put a seed gate at the bottom of the auger to control the seed flow through the auger. A gate gauge strip is on the auger to set the seed flow. The motor that comes with this auger is 1.5 hp. There is a forward/reverse switch wired into it. This switch will work 110v or 220v, a wiring diagram is provided.
The System has 1 mixer. The M2 mixer mounts under the G3 seed treater.
The Mix and Treat has a 120 litre poly tank on a stand with pumps and motor mounted below. This unit is plumbed to draw the liquid product into the tank or send it to the treater. The pumps will cycle the liquid product to mix and restore it to proper suspension. When this is accomplished you can set the unit to pump the seed treatment to the G3 Seed Treater. Note – you cannot transfer liquid product and treat liquid product at the same time. It is necessary to do one action at a time. At the end of the treating season flush the unit with water and then winter safe the pump.